Re: Running Compare Report for PeopleCode

Re: Running Compare Report for PeopleCode

[ Follow Ups ] [ Post Followup ] [ Message Board ]

Posted by [IP Address: 209.195.66.116] 's sills' on September 14, 2001 at 19:14:32 EST:

In Reply to: Running Compare Report for PeopleCode posted by [IP Address: 209.195.66.116] 'Sharon B' on September 13, 2001 at 12:40:03 EST:

You can test by running a small peoplecode compare. For example, you can change a pcode program in your developer play environment and insert it into a project and then run a compare against another db. This should only take a sec to run.

Note that the peoplecode compare is not an sqr based process. You will not see an sqr running when the peoplecode compare runs. (I think pside.exe does the compare. ).

: When trying to kick of PeopleCode compare report, get hourglass, but no processes start. What can I look for to make sure all peices are in the right place to run the PC compare? All SQR compares run fine.

: Thanks in advance.

Follow Ups:

Post a Followup

Name:
E-Mail:
Subject:
Message: : You can test by running a small peoplecode compare. For example, you can change a pcode program in your developer play environment and insert it into a project and then run a compare against another db. This should only take a sec to run. : Note that the peoplecode compare is not an sqr based process. You will not see an sqr running when the peoplecode compare runs. (I think pside.exe does the compare. ). : : When trying to kick of PeopleCode compare report, get hourglass, but no processes start. What can I look for to make sure all peices are in the right place to run the PC compare? All SQR compares run fine. : : Thanks in advance.